Mountz PULSE TOOLS Especificaciones descargar pdf (Pagina 19)

The TorqueMate® Plus and transducers are instruments that should be handled with care. Never over-

load transducers above full capacity. Avoid using impact tools on transducers*. Before use, load the

transducer to full scale in the direction to be used, then zero the display to compensate for any zero off-

set. Zero offset is a normal characteristic of transducers.

The TorqueMate® Plus will accept transducers with up to 2% zero offset. If the transducer has more

than 2% offset the transducer is most likely damaged due to overload. This may result in the inability to

zero the display of the TorqueMate® Plus.

If testing impact tools select a transducer that is twice the expected range of the impact tool and use for reference only.

Do not expect to receive repeatable results when testing impact type wrenches.

Transducers (cont.)

IMPORTANT

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Sin comentarios

Mountz PULSE TOOLS Especificaciones Pagina 19